External ABS Sensor Bracket

Never have to pull wheels again to replace an ABS sensor. Fits between the brake shoe and the axle.

Electronics over time do fail, the elements and road debris are a major factor in failures. Maintenance costs are a major factor in a businesses bottom line, lower maintenance costs and increase the bottom line. Up until now the only way to replace a defective ABS sensor was to remove the nuts from the wheel studs, back the brakes off, remove both wheels and then remove the drum just to get at a sensor. If a sensor is seized, then heat has to be used which could potentially ruin a wheel seal costing even more in labor and equipment downtime.

Once a sensor is replaced, the equipment then has to be reassembled. Anytime wheels are removed, a re-torque sticker MUST be applied and a drive MUST stop and have the wheels re-torqued within 150 km or 93 miles.

Once your order has been sent to me with a valid email address you 

will receive an invoice via email which you can pay with a credit card.

If you choose to pick up or pay your own shipping, click on "estimated shipping costs" in your cart and choose "Free pick up in Cambridge"